Thursday, November 27, 2008

Made to measure

For those who have been wondering about their options when ordering made-to-measure suits, below is a list of alterations which are typically available- far more than the few length and girth adjustments which may have been offered in the past. Keep in mind that the success of the fit relies entirely upon the person measuring you since they are required not only to take measurements but to be able to judge your posture. If you are concerned about the salesperson’s ability to fit you, ask about trunk shows in which representatives of the company which will make the garment will be in store- often there are discounts offered during these shows and you will be sure to have an experienced fitter on hand.

This list is by no means exhaustive (and covers only the jacket- there are more for trousers) but will give you an idea of the flexibility of modern MTM programs.

Lengthen/shorten jacket
Lengthen/shorten sleeve
Button stance higher/lower
Pocket higher/lower
Increase/reduce back
Increase/reduce center front
Increase/reduce waist
Increase/reduce seat
Increase/reduce waist and seat
Sloped shoulder
Square shoulder
Erect
Stoop
Easy armhole
Full chest
Flat chest
Longer/ shorter strap
Dip neck
Pinch neck
Short/long neck
Big/small neck
Forward shoulder point
Big arms
Deeper/higher armhole
Sway back
Round back
Hollow back
Prominent/flat blades
Arms back/forward
Increase/reduce point to point
Left low/ right low

StumbleUpon.com

3 comments:

U. Hurth said...

Interesting,

which programs do that alterations?

R. Jeffery Diduch said...

Just about all the major CAD systems have the capacity to do alterations, but they must be programmed by the designer.

J

Patrick said...

Just got an M2M suit from Brooks Bros and the more I look at it the less I like the shoulders. They are too structured and sharp and when I move I can see there is a good .5 inch of padding. Can the shoulders be softened without destroying the jacket?

Post a Comment